CHOOSING THE RIGHT SIZE HELMET

A proper fitting helmet is integral to a helmet’s performance. Please follow the instructions below to be sure your Xenith product is fitted properly. Measurements for helmet size should be taken 1" inch above the eyebrow around the circumference of the head. The size chart is recommended as a guideline only. Individual head sizes may vary.

digital image of a head being measured with a measuring tape.
Xenith helmets sizing chart.

Adjusting your fit with Adaptive Fit

adaptive fit chinstraps.

Step 1

PLACE THE HELMET ON YOUR HEAD

Unbuckle the straps and place the helmet on your head so the front edge rests just above your brow. Then pull the lower chin straps outward until the chin cup slides up to meet your chin. The internal suspension system will tighten until it feels snug and secure around your head.

adaptive fit chinstraps

Step 2

ADJUST THE LOW BUCKLES AND SECURE

Slide each buckle along the chin strap until you can snap the buckle into place on the outside of the helmet with no discomfort or slack in the straps.

buckling chin straps to helmet

Step 3

ADJUST THE HIGH BUCKLES AND SECURE

Pull the high chin straps upwards so that the chin cup sits comfortably under your chin. Repeat Step 2 on the high straps, snapping them into place once the helmet is secure and fits comfortably – again making sure there’s no slack in the straps.

adjusting helmet once fitted on head

Step 4:

CHECK FOR PROPER FIT

With all four buckles snapped into place, apply mild force to the facemask in multiple directions. If there is excessive movement, tighten the chin straps and readjust the buckles until you’ve achieved a snug, secure fit.

attaching chin straps to helmet

Step 5:

LOCK THE BUCKLES IN PLACE

Once your helmet is comfortable and secure, feed the end of the chin strap through the second slot of each buckle to lock in the fit.

youtube logo xenith x logo
subscribe